Desa EL36L Manuale Utente

www.desatech.com

122663-01D

UNPACkINg AND TESTINg

LOCATINg FIREPLACE

Heater

Flame

Ember

Backlight

Power

Figure 2 - Product Identification

PRODUCT IDENTIFICATION

Heat Vents
(Behind Door)

ON/OFF
Power
Button

Log Set

Front Glass

Heater
Control

Flame Control

Ember Control

Control
Panel
Door

Carefully remove unit from box. Prior to per-
manently installing unit, test to make sure unit
operates properly. Unit does not come with a
power cord installed. Unit must be hard wired
to either a 120/60 or 240/60 volt supply.

CAUTION; The unit must

be connected to a properly

grounded and protected 120/240

volt circuits. Always use ground

fault protection where required

by the electrical code.

WARNING: Do not operate

the unit if it is damaged or has

malfunctioned. If you suspect

the unit is damaged, return the

unit to an authorized service

facility for examination, electri-

cal or mechanical adjustment

or repair.

WARNING: Due to high tem-

peratures, this heater should

be located out of traffic. Keep

combustible materials such

as furniture, pillows, bedding,

papers, clothes and curtains at

least 3 feet (0.9 m) from the front

of the heater.

WARNING: Never locate this

heater where it may fall into a bath-

tub or other water container.

NOTICE: Minimum and maximum

clearances must be maintained at

all times. Illustrations throughout

these instructions reflect typical

installations and are for design

purposes only. Actual installa-

tions may vary slightly due to

individual preferences.

WARNING: To prevent

contact with sagging or loose

insulation, the heater must not

be installed against vapor barrier

or exposed insulation. Localized

overheating could occur and a

fire could result.

Backlight
Control

Remote Hide

Magnetic
Catch