National Instruments 653X Manuale Utente

5.

Insert the AT-DIO-32HS into an AT (16-bit ISA) or EISA slot. It can 
be a tight fit, but do not force the device into place.

6.

Screw the mounting bracket of the AT-DIO-32HS to the back panel rail 
of the computer.

7.

Visually verify the installation. Make sure the device is not touching 
other boards or components and is fully inserted in the slot.

8.

Replace the cover of the computer.

9.

Plug in and turn on your computer.

Now that your 653X device is installed, it is ready to be configured.

You can install your DAQCard-6533 for PCMCIA in any available 
CardBus-compatible Type II PCMCIA slot. Consult the computer 
manufacturer for information about slot compatibility.

1.

Turn off your computer. If your computer and operating system 
support hot insertion, you may insert or remove the DAQCard-6533 
at any time, whether the computer is powered on or off.

2.

Remove the PCMCIA slot cover on your computer, if any.

Now that your 653X device is installed, it is ready to be configured.

Your 653X device is configured automatically in Measurement & 
Automation Explorer (MAX), which is installed with the NI-DAQ 
driver software in Windows, or in the NI-DAQ Configuration Utility, 
which is installed with NI-DAQ in the Mac OS. All settings are initially 
configured to default settings.

If you would like to change or view default settings, follow these 
instructions, also available in your DAQ Quick Start Guide:

1.

Launch MAX.

2.

Open Devices and Interfaces.

3.

Right-click the device you want to configure and choose Properties.

4.

Press the Test Resources button to test hardware resources.