Brother FAX 2600 Manuale Utente

      A S S E M B L Y   A N D   C O N N E C T I O N S

Set your external TAD to four rings or less. (The FAX/MFC’s Ring Delay 
setting does not apply).

Record the outgoing message (see below).

Set the TAD to answer calls.

Set the Receive Mode to TAD: ANSWER MACH. (Press 

.)

Timing is important in recording this message. The message sets up the ways to 
handle both manual and automatic fax reception.

Record 5 seconds of silence at the beginning of your message. (This allows your 
FAX/MFC time to listen for the fax CNG tones of automatic transmissions 
before they stop.)

Limit your speaking to 20 seconds.

End your 20-second message by giving your Fax Receive Code for people 
sending manual faxes. For example:
“After the beep, leave a message or send a fax by pressing   5 1 and Start.”

Your FAX/MFC is equipped with a handset that you can use as a regular phone. 
However, you can also connect a separate telephone (or telephone answering 
device) directly to your FAX/MFC.

Connect the modular plug on the telephone’s line cord to the jack labeled EXT. 
on the left side of the FAX/MFC. 

Whenever this phone (or TAD) is in use, the screen displays EXT. TEL IN USE, 
and, if the FAX/MFC handset is lifted, an alarm sounds. To disconnect the call 
on the external phone and switch to the FAX/MFC, press 

. 

A roll over phone system is a group of two or more separate telephone lines that 
pass incoming calls to each other if they are busy. The calls are usually passed 
down or “rolled over” to the next available phone line in a preset order. 

Your FAX/MFC can work in a roll over system as long as it is the last number 
in the sequence, so the call cannot roll away. Do not put the FAX/MFC on any 
of the other numbers—when the other lines are busy and a second fax call is 
received, the fax call would be transferred to a line that does not have a fax 
machine. Your FAX/MFC will work best on a dedicated line.