Dyson cr01 Manuale Utente

In future, refer to programme table

section

9.01  

for recommended loads.

Remove some items or reload your

machine and select spin only programme

see section  

8 01 

then press start.

Close outer door, ensuring nothing is

trapped and press start again.

Close inner door, ensuring nothing is

trapped and press start again.

Refer to

10.02 

for removing blockages

and press start.

Check drainage hose is not blocked

or kinked and press start.

Check that water supply is connected,

turned on at the tap, and press start. 

Clean filters as detailed in section 

10.03

and press start.

Check inlet pipes are not blocked

or kinked and press start.

Check that drainage hose is installed in

accordance with the installation 

instructions in sections

and press start.

Contact Dyson Helpline 08706 002 701

or visit our website www.dyson.com with

the following information:

your machine’s serial number.

where you purchased your machine.

when you purchased your machine.

your address.

the fault code that appears on the LCD

display, if applicable.

11 

03

Troubleshooting

Overload reduced performance

Uneven load cannot spin

Close outer door then press start

Close inner door then press start

Not emptying: check hose and

coin trap

Not filling: check water supply

Fault

The recommended wash load has been

exceeded

The wash load is uneven

Coin trap blocked

Drainage hose not draining

Water supply is not connected

Filter is blocked

Inlet pipes are blocked or kinked

Drainage hose is installed incorrectly

These are technical faults with your

machine.

Most queries can be solved over the

telephone by one of our trained customer

care staff. If they cannot, a qualified

Dyson service engineer will visit you to

repair and test your machine.

8

01,

9

01

10

02

10

03

5

01 & 

5

02

Ensure machine is plugged in and

switched on. Check fuse and circuit

breaker has not tripped.

See section  

9.01

for the programme

options wash table.

Hold down ‘Minimum iron’ button until

‘Child lock off ’ is shown on LCD

display and child lock light is off.

Wait for machine to finish cycle before

opening the door. Cancel wash by

holding down ‘Cancel’ button.

For safety reasons the door stays locked.

Press flashing start button to resume

programme.

Hold down ‘Minimum iron’ button until

‘Child lock off ’ is shown on LCD

display and child lock light is off.

Follow ‘Emergency door release’

instructions in section

Turn off water supply to machine

ensuring that coin trap cover is correctly

fitted, see section

Check discharge hose is draining into a

suitable place (drain, sink or standpipe). 

Close soap tray.

Adjust feet until machine is level as

described in section

Return Rollerjack

TM

handle to its position

under machine, see section

LCD display is blank

Certain spin speeds, temperatures, dirt

levels cannot be selected

Cancel button does not work during

the cycle

Cannot open door

Machine leaks water

Machine shakes during the cycle

There is no power to the machine

To maximise wash performance and

protect the clothes, there are limits on the

temperatures, spin speeds and dirt levels

for each programme

Child lock is active

Washing machine has not finished cycle

Machine is paused

Child lock is active

Power cut or any other cause not listed

Coin trap cover is not in place

Discharge hose is not connected correctly

Soap tray is open

2 adjustable front feet are not level

Rollerjack

TM

handle is still out

11 

02

Troubleshooting

9

01

5

03.

4

01.

10

03.

10

02.