KYOCERA taskalfa fs-1100 Manuale Utente

3-2

Connecting and Printing

This section explains how to start up the printer.

Follow the steps as below for connecting the USB cable.

1

Connect the USB cable (not included) to the USB Interface 
Connector.

2

Connect the other end of the USB cable to the computer's USB 
interface connector.

Install the printer close to an AC wall outlet. If an extension cord is used, the 
total length of the power cord plus extension should be 5 meters (16 feet) or 
less.

1

Connect the power cord to the Power Cord Connector at the rear of 
the printer.

2

Connect the other end of the power cord to a power outlet.

3

Press the Power Switch to On ( | ). The printer begins to warm up.

Use a USB cable with a rectangular Type A plug and a 

square Type B plug. The USB cable should be shielded and 
no longer than 5 meters (16 feet) long. 

Ensure the printer's power switch is off. Only use the power 

cord supplied with the printer. 

If you install the toner container and switch on the 

power, after a moment the indicators light in anticlockwise 
direction. When the printer is first switched on after toner 
installation, there will be a delay of approximately 15 minutes 
before the printer gets ready to print. Once the 

[Ready] indicator 

lights, printer installation is complete.