KYOCERA taskalfa fs-1100 Manuale Utente

4-2

Maintenance

This chapter describes basic maintenance tasks you can perform for the 
printer. You can replace the toner container according to the printer's 
status:

Also, the internal parts need periodic cleaning.

The Toner indicator identifies the toner status at two stages of toner 
usage. 

When the printer becomes low on toner, the 

Toner indicator flashes. 

Note the replacement is not always necessary at this stage. 

If you ignore the above status and continue printing, the 

Toner 

indicator lights up just before the toner is used up. The toner 
container must then be replaced immediately.

In either case, replace the toner container. 

Assuming an average toner coverage of 5% and EcoPrint mode turned 
off, the toner container will need replacing approximately once every 
7,200 pages (FS-1300D) or 4,000 pages (FS-1100).

The toner container packed with the new printer is a starter toner 
container. The starter toner container lasts an average of 3,600 pages 
(FS-1300D) or 2,000 pages (FS-1100).

For best results, we recommend that you only use genuine Kyocera 
Parts and Supplies.

A new toner kit contains the following items:

Toner Container

Plastic waste bag for old toner container

Installation Guide

Information Collection on Memory Chips - The memory chip 

attached to the toner container is designed to improve 
convenience for the end user; to support the recycling operation of 
empty toner containers; and to gather information to support new 
product planning and development. The information gathered is 
anonymous - it cannot be associated to any specific individual and 
the data is intended to be used anonymously. 

Do not remove the toner container from the carton until you 

are ready to install it in the printer.