Belkin apfirmware Manuale Utente

 

To make any changes to the configuration of the WAP, you must connect to 
the WAP by entering a password. The WAP is password-protected to keep 
unauthorized users from changing settings. 

1.  Click on "Command" and select "Connect AP…" in the drop-down menu. 

 

 

 
The "Input Password" window will appear. Your WAP ships from the factory 
with the password set to "MiniAP". Keep in mind that the password is case-sensitive, 
and enter the password. 
Password = "MiniAP" (case-sensitive) 
 
When connected, the word "Connected" will appear under the column 
labeled "State". If you cannot connect, see the troubleshooting tips at the 
end of this manual. 
 
Step 5: Upgrading the firmware for the WAP 

 

1.  Click on “Command” and then “Update Firmware...”  
2.  Use the browse button to locate the firmware that was downloaded to the hard drive: