Cambridge Audio 540d v2 Manuale Utente

RGB/SCART

Use a SCART/Peritel cable to connect to the 21-pin scart input jack of a

TV. SCART carries both audio (stereo) and video (as either Composite, S-

Video or RGB) at the same time.

Analog Video Outputs

Composite - Connect to your television via 75 ohm RCA/phono cable

designed specifically for video use.

S-VVideo - Connect to your television via dedicated S-Video cable.

Component - Connect to the YCbCr or YPbPr terminals of a television set

via three 75 ohm RCA/phono cables designed specifically for video use.

HDMI Out

HDMI (High-Definition Multi-Media Interface) is a purely digital

connection that can carry both audio and video. Use a dedicated HDMI

cable to connect to a TV/Monitor with a compatible HDMI input.

540D V2

azur

Rear panel connections

ENGLISH

AC power socket

Once you have made all audio and video connections, plug the IEC type

AC power cable into the rear of the unit and an appropriate mains socket

then switch on. Your DVD player is now ready for use.

Power On/Off

Switches the unit on and off.

Control Bus

In - Allows un-modulated commands from multi-rooms systems or other

components to be received by the unit.

Out - Loop out for Control Bus commands to another unit.

IR (Infra-Red) Emitter In

Allows modulated IR commands from multi-room systems or IR repeater

systems to be received by the unit. Commands received here are not

looped out of the Control Bus. Refer to the ‘Custom Installation’ section

of this manual for more information.

Digital Outputs

Digital audio outputs are normally used to connect to a suitable

Audio/Video Receiver for surround sound decoding (output must be set

for ‘RAW Bitstream’ - refer to the ‘Audio setup’ section). These outputs

can also be used to connect to a separate DAC or digital recording

device (output must be set for ‘PCM Stereo’ - refer to the ‘Audio setup’

section).

Toslink Optical - Use a high quality TOSLINK fibre optic cable.

S/P DIF Co-AAxial Digital - Use a high quality 75 ohm digital RCA/Phono

interconnect cable designed specifically for digital audio use.

5.1 Channel Audio Out

If Downmix is set to ‘Off’ in the Speaker Setup section of the 540D V2’s

Setup menus, these sockets provide 5.1 output from the 540D V2's built

in Dolby Digital / Pro Logic II decoder. This can be used to connect to the

5.1 audio line-level inputs of an amplifier/AV receiver or amplified

speaker package if required.

If Downmix is set to ‘On’, the Left and Right outputs only are active and

provide a stereo downmixed output.

Stereo Audio Out

A separate permanent Stereo output (or Stereo downmix in the case of

multi-channel material) is available for connection to the analog stereo

inputs of an amplifier/AV receiver etc. This is the best connection to use

for listening to CDs.

Power AC

Off

Power

SCART (Composite/RGB/Stereo Audio)

Out

www.cambridge-audio.com

Toslink

Optical

S/P DIF

Co-axial

azur 540D V2.0 DVD Player

Power Rating

: 100-240V AC ~ 50/60Hz

Max Power Consumption

: 25W

Designed in London, England

Composite

S-Video

Cr/Pr

Cb/Pb

Component

Video Out

5.1 Channel Audio Out

This product complies with DHHS rules 21 CFR, Chapter 1,

Subchapter J, Part 1040 at date of manufacture.

Apparatus claims of US patent nos. 4,631,603; 4,577,216;

4,819,098 and 4,907,093 licensed for limited viewing only.

“DTS” is a trademark of Digital Theatre Systems Inc.

Manufactured under license from Dolby Laboratories.

“Dolby” and the double-D symbol are trademarks of Dolby Laboratories.

Confidential Unpublished Works

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: 1) This device may not cause

harmful interference; 2) This device must accept any interference,

including interference that may cause undesired operation.

Class 1 Laser Product

Luokan 1 Laserplaite

Klass 1 Laserapparat

Stereo

Out

Digital Outputs

HDMI Out

Manufactured in an ISO9002 approved facility.

Control Bus

IR Emitter

Caution

Risk of electric shock.

Do not open.

Avis

Risque de choc electrique.

Ne pas ouvrir.

Achtung

Vorm öffnen des gerätes.

Netzstecker ziehen.

Note: The preferred connection method for video sources is always

HDMI (highest quality, and can also carry audio in some

circumstances) then Component Video then RGB/SCART then S-

Video then Composite Video (lowest quality). The HDMI and

Component outputs also support Progressive Scan which gives

better picture quality if supported by your TV.