DOD vofx Manuale Utente
• by turning the Data wheel in Performance mode.
To select Programs using the footswitches:
1) After you power up, the VoFX defaults to Performance mode. Select a Bank by
pressing the Bank selector footswitch. The display shows the selected bank
number on the left side of the display and a dash on the right. The display
might look something like this:
pressing the Bank selector footswitch. The display shows the selected bank
number on the left side of the display and a dash on the right. The display
might look something like this:
2) Press footswitch 1, 2, or 3. The dash in the display changes to show the
number of the Program you selected. The display might look something like
this:
number of the Program you selected. The display might look something like
this:
NOTE: If a new Program number is not selected within 5 seconds after pressing
the Bank select button, the display returns to its previous setting.
the Bank select button, the display returns to its previous setting.
Editing Programs
As you become more familiar with the VoFX, you may find that you need to
modify certain Programs to better fit your needs. Fortunately, the VoFX is flexi-
ble enough to give you everything you need without being difficult to program.
modify certain Programs to better fit your needs. Fortunately, the VoFX is flexi-
ble enough to give you everything you need without being difficult to program.
The following procedure is an example of how to modify your Programs.
Suppose that a Program which has a 100 ms mono delay, a medium chorus,
noise gate, EQ, Mic Driver, and compression sounds close to what you want,but
you want a 300 ms delay with low feedback instead. Here's how to change it:
Suppose that a Program which has a 100 ms mono delay, a medium chorus,
noise gate, EQ, Mic Driver, and compression sounds close to what you want,but
you want a 300 ms delay with low feedback instead. Here's how to change it:
1) Use the Data wheel, or the Bank and Program selector footswitches to select
the desired Program.
the desired Program.
2) Press the Delay effect group button. The Delay group Status LED begins
flashing and the display reads:
flashing and the display reads:
11
23
2-
Signal Processing
7
Signal Processing
VoFX manual 7/25/00 11:04 AM Page 7