Crestron qs c2n-dap8 Manuale Utente
Digital Audio Processor
Crestron C2N-DAP8
Connect Outputs
Connect audio outputs from the DAP8 using the diagram below as a guide.
Network ID
The Net ID of the DAP8 is factory set to 50. The Net IDs of multiple DAP8s in the same system must be
unique, and the Net ID of each unit must match an ID code specified in the SIMPL Windows program. Refer
to “Identity Code” on page 10 of the Operations Guide for the DAP8 (Doc. 8186) for details.
unique, and the Net ID of each unit must match an ID code specified in the SIMPL Windows program. Refer
to “Identity Code” on page 10 of the Operations Guide for the DAP8 (Doc. 8186) for details.
Communication Setup
To upload a SIMPL Windows program or the
example program for the DAP8, it is necessary
to establish communications with a 2-Series
control system.
example program for the DAP8, it is necessary
to establish communications with a 2-Series
control system.
• Use a standard DB9 male to female
“straight-through” cable, to connect a
PC’s serial port to the control system’s
computer port.
PC’s serial port to the control system’s
computer port.
• Use a 4-wire Cresnet cable to connect
the DAP8 to the control system.
If communication cannot be established, refer
to the “Troubleshooting Communications”
section in the Operations Guide for the control
system.
to the “Troubleshooting Communications”
section in the Operations Guide for the control
system.
2
• Digital Audio Processor: C2N-DAP8
Quick Start – DOC. 6231