Desa VM36(B,H) Manuale Utente

www.desatech.com

108795-01V

6. Repeat the process for the opposite door

assembly.

7. To adjust doors, slide them partially open.

Using a screwdriver, loosen hold-down
screws in the spring clip (see Figure 36)
and pivot plate.

8. Close both doors until evenly joined at the

middle and note the gap at outer edges of
face.

9. Reopen one door at a time and retighten

upper and lower hold-down screws.

10. Repeat process until both doors are even-

ly joined, spaced and working freely.

CAUTION: The glass pan-

els become very hot while the

appliance is operating. Do not

attempt to adjust or clean the

glass doors until the appliance

has fully cooled.

The doors may be removed for replacement
or cleaning as follows:
1. Partially open door and press up on upper

spring clip with a screw driver until outer
top pivot pin is free of clip.

2. Fully fold frame assembly and slide upper

edge towards center of firebox opening
until guide pins are free of frame rail (see
Figure 37).

CAUTION: Always operate

the appliance with the doors ei-

ther fully opened or fully closed.

Operating the appliance with

the doors partially open can re-

sult in improper venting of flue

products.

INstallatIoN

Continued

Figure 36 - Adjusting Glass Doors

Spring
Clip

Hold-Down
Screw

Side
Front
Face

Partially
Opened
Door

Figure 37 - Removing Glass Doors

Spring Clip

Press
Spring Clip
to Release
Pivot Pin

Remove Bottom Pin From
Pivot Plate While Sliding Door
Out of the Upper Track

Pivot Plate

Fold Bi-Fold
Door After
Releasing
Spring Clip
and Slide
Door Out of
Upper Track

OPENING VENT DAMPER

Vent damper must be locked in the full open
position before operating fireplace. If vent
damper is not open, fireplace will not light.

OPEN

VENT DAMPER MUST BE LOCKED

IN THE FULL OPEN POSITION

TO OPERATE THE APPLIANCE

Figure 38 - Opening Vent Damper