Cub Cadet cub cadet snow blower 945 swe Manuale Utente

4. 

Looking beneath the handle panel, check that all of the 

cables (steering, auger, and drive) are properly routed and 

not pinched or kinked. Make certain the springs at the lower 

end of the auger and drive cables are securely hooked into 

their respective actuator bracket. See Figure 3-11.

5. 

Secure the upper handle, support tubes and lower handle 

with the two wing nuts, bell washers and carriage bolts 

removed earlier. Tighten the two wing nuts already 

installed in the upper holes to firmly secure the upper 

handle and support tubes. See Figure 3-3.

Two replacement auger shear pins are included 

with this manual (or stowed in the plastic handle panel). Refer to 

the Maintenance section for more information regarding shear 

pin replacement.
NOTE: All references in this manual to the left or right side of the 

snow thrower is from the operating position only. Exceptions, if 

any, will be specified.

This unit is shipped with the engine full of oil. 

After assembly, refer to the separate Engine Owner’s Manual 

included with this unit for fuel and oil fill-up details.
NOTE: Specifications are subject to change without notification 

or obligation. Images may not reflect your exact model and are 

for reference purposes only.

1. 

Remove any packaging material from the upper handle. 

2. 

Remove the lower wing nut, bell washer and carriage bolt 

from each side of the upper handle, as seen in Figure 3-1.

3. 

Raise the upper handle assembly until it snaps over the 

lower handle. See Figure 3-2.

• 

One Snow Thrower

• 

One Engine Operator’s Manual

• 

One Chute Assembly

• 

One Snow Thrower Operator’s 

Manual

• 

Two Replacement Auger Shear Pins

• 

One Product Registration Card