Garmin 2006 Manuale Utente

7.5" (190 mm)

5.91"

(150 mm)

TRIM TEMPLATE ALONG THIS LINE TO AID FITTING 

Drill a 3/8" (6 mm) hole.  

Begin cutting here.

Be very careful when cutting this hole, 

because there is only a small amount 

of clearance between the unit and the 

mounting hole.

 

1. Trim the flush mount template and tape it in the preferred location.
2. Using the center punch, indent the center of each mounting hole location.
3. Using an 1/8" (3 mm) drill bit, drill the four mounting holes. (Drilling the mounting 

    holes before cutting the hole for the unit allows for an easier installation.)
4. Using a 3/8" (6 mm) drill bit, drill a hole to begin cutting the mounting surface.
5. Using the jig saw, cut the mounting surface along the inside of the dashed line

    indicated on the template. Be very careful when cutting this hole, because there is only a 

    small amount of clearance between the case molding and the mounting holes.
6. Install the four mounting studs into unit by screwing the shorter, threaded section 

    into the back of the unit. Use a .05" Allen wrench to tighten the mounting studs

    until the stop contacts the case. Be careful not to overtighten, because this may damage the 

    mounting stud! The studs have a reusable thread-locking patch pre-applied from the factory.
7. Place the unit into the cut out of the mounting surface.
8. Place washers over the mounting studs, then thread on one hex nut per mounting stud.

    Tighten all four until the unit is snug against the mounting surface.

    Install and tighten the second hex nut on all four mounting studs to lock the first one 

    in place.

Garmin International  1200 E. 151st Street, Olathe, KS 66062 

190-00243-00 Rev. F   

April 2006 

 

 

 

Printed in Taiwan