Garmin g1000 mooney primaryflightdisplay pilots guide m20m m20r Manuale Utente
190-00443-00 Rev. A
Garmin G1000 PFD Pilot’s Guide for Mooney M20M & M20R
3-40
SUPPLEMENTAL FLIGHT DATA
Load Arrival
Load Arrival allows the pilot to select a published stan-
Load Arrival allows the pilot to select a published stan-
dard terminal arrival route (STAR) for the destination air-
port, or replace a current arrival with a new selection.
port, or replace a current arrival with a new selection.
NOTE
:
The PROC key can also be used to load a
departure, an approach, or an arrival.
To select an arrival for a direct-to or flight
plan destination airport:
1. From the Flight Plan window, press the MENU
key to display the page menu options.
2. Turn the
FMS knob to highlight ‘Load Arrival’,
then press the
ENT key. A window appears
listing the available arrivals for the destination
airport.
3. Turn the FMS knob to select the desired arrival,
then press the
ENT key. A window appears
listing available transitions for the arrival.
4. Turn the
FMS knob to select the desired transi-
tion waypoint, then press the
ENT key.
NOTE: This runway window is not displayed for
every arrival. ‘ALL’ may appear in the runway
field, indicating that the arrival procedure applies
to all runways. For airports with parallel runways,
‘B’ may appear at the end of the runway designa-
tion to indicate that the arrival procedure applies
to both runways.
field, indicating that the arrival procedure applies
to all runways. For airports with parallel runways,
‘B’ may appear at the end of the runway designa-
tion to indicate that the arrival procedure applies
to both runways.
5. A window may appear listing runways for the
arrival. Turn the
FMS knob to select the desired
runway, then press the ENT key. With ‘LOAD?’
highlighted, press the
ENT key.
NOTE: When adding an arrival to an active flight
plan, the pilot may need to remove a duplicate
destination waypoint from the flight plan list.
destination waypoint from the flight plan list.
Load Approach
Load Approach allows the pilot to select a published
Load Approach allows the pilot to select a published
instrument approach for the destination airport, or re-
place the current approach with a new selection.
place the current approach with a new selection.
To select an approach for a direct-to or
flight plan destination airport:
1. From the Flight Plan window, press the
MENU
key to display the page menu options.
2. Turn the
FMS knob to highlight ‘Load Approach’,
then press the
ENT key. A window appears list-
ing the available approaches for the destina-
tion airport.
3. Turn the FMS knob to select the desired
approach, then press the
ENT key. A window
appears listing the available transitions for the
approach.
NOTE: The ‘Vectors’ option assumes that the pilot
will receive vectors from ATC to the final course
segment of the approach.
4. Turn the FMS knob to select the desired transi-
tion or vectors, then press the
ENT key. With
‘LOAD?’ highlighted, press the
ENT key to load
the approach.
5. To activate the approach, turn the large FMS
knob to highlight ‘ACTIVATE?’, then press the
ENT key.
NOTE: ‘LOAD’ adds the approach to the flight
plan without immediately using the approach
for navigation guidance. This allows the pilot
to continue navigating the original flight plan
until cleared for the approach, but keeps the
approach available for quick activation when
needed. ‘ACTIVATE’ adds the approach to the
flight plan and begins navigating the approach
course.