Garmin stylus nx300 Manuale Utente
Replacing Ink Cartridges
39
4. Before you open the new cartridge package, shake it four or five times. Then
remove it from the package.
Caution:
Do not touch the green chip on the back of the cartridge, or you may damage it.
Do not touch the green chip on the back of the cartridge, or you may damage it.
5. Remove the yellow tape from the bottom of the ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will leak.
Do not remove any other labels or seals, or ink will leak.
6. Insert the new ink cartridge into the holder and push it down until it clicks
into place.
7. Once you replace all the cartridges that need replacing, close the cartridge
cover and push it down until it clicks into place.
8. Lower the scanner.
9. Press
OK
to begin charging the ink. This takes about 2 minutes. When you
see a completion message on the display screen, ink charging is finished.
10. Press
Menu
to exit.
Caution:
Never turn off the NX300/305 Series while ink is charging, or you’ll waste ink. If you see
an ink replacement message on the display screen, press
Never turn off the NX300/305 Series while ink is charging, or you’ll waste ink. If you see
an ink replacement message on the display screen, press
OK
and press down all the
cartridges securely.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.
cartridge.