Grizzly g8724 Manuale Utente

CoPyRiGHT © SEPTEMBER, 2008 By GRizzLy indUSTRiAL, inC.

#CR11180 PRinTEd in CHinA

1.  Before using this bottle jack make sure that it

is filled with a standard hydraulic oil and that
the air is bled from the system.

2.  Refer  to  your  vehicle  owner's  manual  to

locate  the  safe  lifting/support  locations,  and
to  verify  that  the  lifting  point  of  the  vehicle
does  not  exceed  the  maximum  load  for  the
bottle jack.

3.  Make sure the vehicle engine is OFF.

4.  Apply the vehicle emergency brake and make

sure that the vehicle is on flat stable ground.

5.  Block the wheels to prevent the vehicle from

rolling.

6.  Set  the  transmission  in  PARK  (automatic)

or REVERSE (manual).

12.  Place  the  valve  control  socket  shown  in

Figure  1  on  the  release  valve,  and  slowly
turn the valve counterclockwise so the vehi-
cle slowly lowers onto the jack stands.

13.  double  check  that  the  jack  stands  are  sup-

porting the vehicle safely.

14.  Close the control valve on the jack. if possible

for  additional  safety  and  a  quick-lift  option
leave the jack in its lifting position.

Figure 2. oil fill plug.

Rubber Plug

3.  Use the valve control socket at the end of the

handle  to  close  (turn  clockwise)  the  release
valve  (

Figure  1),  then  pump  the  jack  a  few

times to bleed the hydraulic system.

4.  Repeat Step 2 to top off the hydraulic oil.

7.  Position  the  bottle  jack  under  the  vehicle

where the owner's manual indicates is a safe
location.

8.  Rotate  the  gripping  elevation  screw  until  it

contacts the lifting point on the vehicle.

9.  Use the valve control socket at the end of the

handle  to  close  (turn  clockwise)  the  release
valve.

10.  While staying clear from the underside of the

vehicle, pump the jack and raise the vehicle
to the appropriate height.

11.  While staying clear from the underside of the

vehicle,  place  and  lock  your  jack  stands  at
the appropriate support locations.