Garmin gmr 606 Manuale Utente

Pagina di 14
GMR 600/100 Series Installation Instructions 
 
Installing the Mounting Studs and Seals
1.  Remove the hatch on the front of pedestal by loosening the screw and lifting the hatch off of the hinges as shown in Figure 1.
2.  Use a 5 mm Allen wrench, to install the M10 x 71 mounting studs (Figure 2) in the pedestal matching the hole pattern that was selected. 
Tighten the mounting studs until they bottom out in the pedestal. Do not overtighten the studs to avoid damaging the pedestal. The mounting 
studs have a thread-locking patch applied at the factory.
 
Optional: Apply moisture-inhibitive grease or paste to the four studs prior to installation.
3.  Install the seals onto the pedestal (Figure 3).
Figure 1
Figure 2
Figure 3
Mounting the Radar
Mount the radar with either end pointed toward the bow. Ensure it is mounted along the Bow-Stern Axis line indicated on the GMR 
400/600/1200 Series Mounting Template. If the end with the hatch is pointed toward the bow, the Front of Boat Offset setting on the chartplotter 
must be set to 180° (Figure 4). To adjust the Front of Boat Offset on the chartplotter, see 
.
To mount the radar:
1.  (Skip to step two if you are using a pre-drilled Garmin compatible Furuno
®
 or Raymarine
®
 mount.) Determine a suitable mounting location 
and tape the Mounting Template in place. The Mounting Template has two hole patterns: Option A and Option B. Determine the most 
appropriate patterns from the two patterns available on the Mounting Template (Option A or Option B). Use a 
1
/
2
 in. (13 mm) bit to drill the 
four mounting holes. 
2.  Hoist the radar into position using the supplied strap. Position the strap over the ends of the antenna mount as shown in Figure 5. Ensure 
that you position the strap as close to the radar as possible.
3.  Fasten the radar to the mounting surface using the M10 hex nuts, spring washers, and flat washers in the order shown in Figure 6. The M10
nuts should be torqued to 130 lbf-in (11 lbf-ft) (1.5 kgf-m). 
Figure 5
Figure 6
flat washer
spring washer
M10 hex nut
Figure 4
Bow
Stern
Bearing Offset = 0°
Bearing Offset = 180°
Waveguide protective cover