Casio signature xj-m255 Manuale Utente

IP Setup

Obtain an IP 
address 
automatically/
Use the following IP 
address

Specifies whether you want to obtain an IP address automatically or specify an IP 
address manually.

z Selecting “Use the following IP address” applies IP address, subnet mask, and 

default gateway information that you input manually.

z Specification of IP address, subnet mask, and default gateway information is 

not necessary (and is not allowed) when you select “Obtain an IP address 
automatically”.

Initial Default: Obtain an IP address automatically

IP Address

Specifies the projector’s IP address.
Initial Default: 192.168.100.10

Subnet Mask

Specifies a subnet mask value, which specifies the IP address range of the subnet 
to which the projector belongs.
Initial Default: 255.255.255.0

Default Gateway

Specifies the subnet default gateway.
Initial Default: 192.168.100.10

DHCP Setup

Auto/Disable

Specifies whether an IP address should be assigned automatically to a computer 
connected to the projector via wireless LAN. “Auto” causes an IP address to be 
assigned automatically, while “Disable” turns off auto assignment.
Initial Default: Auto

Starting IP Address

Specifies the start point of the range of IP addresses that are assigned 
automatically to computers. This setting is available only while “Auto” is selected 
for the DHCP Auto/Disable setting.
Initial Default: 192.168.100.11

Ending IP Address

Specifies the end point of the range of IP addresses that are assigned 
automatically to computers. This setting is available only while “Auto” is selected 
for the DHCP Auto/Disable setting.
Initial Default: 192.168.100.254

Wireless Setup

SSID

Wireless network ID name. This is normally referred to as the SSID, ESS-ID, or 
network name. Up to 24 single-byte alphanumeric characters can be entered.
Initial Default: casiolpj_default1

SSID Broadcast

Specifies whether SSID information broadcasting is enabled or disabled.
Initial Default: Enable

Channel

Specifies the channel used for wireless LAN communication. Selecting “Auto” 
causes auto selection of a channel that is appropriate for the current 
communication environment. To specify a channel number, select channel number 
1 through 11 from the list that appears when you click the [

T] button to the right of 

the channel number.
Initial Default: Auto

Security

Specifies the security protocol. For more information, see “To configure security 
settings” (page 21).
Initial Default: WPA-PSK AES

Passphrase/WEP 
Key

Specifies the passphrase or WEP key in accordance with the security protocol 
selected with “Security” above. For more information, see “To configure security 
settings” (page 21).

IEEE 802.11n

Specifies whether wireless LAN standard IEEE 802.11n is enabled.
Initial Default: Enable

Channel Width

Specifies either “20MHz” or “Auto” for the IEEE 802.11n channel width.
Initial Default: 20MHz

Projector name

Input up to 32 characters for a name to be used as the projector’s identity.