Zebra 49834 Manuale Utente
Troubleshooting
Print Engine Diagnostics
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
123
Communications Diagnostics Test
Do not perform the following test until all configuration and calibration parameters have been
set. For configuration information, see
set. For configuration information, see
.
This test is controlled from the front panel display. See
.
shows a typical printout from this test. Turn the print engine power Off (O) and then
back On (I) to exit this self test and return to normal operation.
Figure 51 • Communications Diagnostics Test Label
B:Memory
Fixed (option card)
J12 Interface
Fixed
J11 Interface
Fixed
J10 Interface
Fixed
J9 Interface
Fixed
J8 Interface
Fixed
J7 Interface
Fixed
Twinax/Coax ID
ZPL
Table 17 • Control of Parameters (Continued)
Parameter
Controlled By
Note •
This test label prints upside-down.