INSTEON 2443-522 Manuale Utente

Page 13 of 21

2443-222/2443-422/2443-522 - Rev: 1/21/2014 8:28 AM

6) After beep stops, release Micro module Set button

After a few seconds, the LED will flash white
Micro module will double-beep and the load will turn on

X10 Setup

Micro module ships with no X10 address assigned.

Add X10 Address

1) Press and hold Set button until it beeps

LED will start blinking green

2) Send the X10 address 3 times (with or without commands)

Example: A1-AON-A1-AON-A1-AON or A1-A1-A1-AON
Micro module will double-beep and LED will stop blinking

3) Test by sending X10 on and off commands

Load will turn on and off

Remove X10 Address

1) Press and hold Set button until it beeps

LED will start blinking green

2) Press and hold Set button until it beeps again

LED will start blinking red

3) Send the X10 address 3 times (with or without commands)

Example: A1-AOFF-A1-AOFF-A1-AOFF or A1-A1-A1-AOFF
Micro module will double-beep and LED will stop blinking

4) Test by sending X10 on and off commands

Micro module will not respond