INSTEON 2476d Manuale Utente

 

If you are no longer going to control a SwitchLinc Dimmer with an INSTEON Controller, it is very 
important that you unlink it, because otherwise the controller will retry any commands intended for the 
unused SwitchLinc Dimmer, thus slowing down your system. 

1.  Select your INSTEON Controller from the list below and follow the method shown to put it into 

Unlinking Mode. 

A.  A Second SwitchLinc V2 Dimmer – Follow the instructions in the section 

Unlinking a Controlled INSTEON Device from SwitchLinc Dimmer, above.  
(Briefly, press and hold the Second SwitchLinc Dimmer’s Paddle Top for 10 
seconds twice.) 

 

B.  ControLinc

™ V2 Tabletop Controller – Press and hold the OFF Button of 

the ON/OFF Button Pair you used for controlling SwitchLinc Dimmer for 10 
seconds.  To confirm that it is in Unlinking Mode, ControLinc V2’s Status LED 
will begin blinking. 

 

C.  KeypadLinc

™ V2 – Press and hold for 10 seconds the ON Button you used 

for controlling SwitchLinc Dimmer, then press and hold the same ON Button 
for 10 seconds again.  To confirm that it is in Unlinking Mode, KeypadLinc V2 
will flash the light that it is wired to once and begin blinking the ON Button that 
you pushed.  

 

D.  Other INSTEON Controllers – See the INSTEON Controller’s User’s Guide. 

 

 

2.   Press and hold the Paddle Top for 10 seconds on the SwitchLinc Dimmer 

that is being controlled.  To confirm unlinking, the SwitchLinc Dimmer will 
blink the top LED in its LED Bar and also the light that it is wired to.  
Depending on the INSTEON Controller, you have about 4 minutes to 
perform this step before Unlinking Mode times out automatically. 

 

 

 

Page 17 of 35