Linak techline la35 Manuale Utente
Mounting guidelines
LINAK
®
linear actuators are quickly
and easily mounted by slipping pins
through the holes on each end of
the units and into brackets on the
machine frame and the load.
The mounting pins must be parallel
to each other as shown in Figure 1.
Pins, which are not parallel to each
other, may cause the actuator to
bend and be damaged.
through the holes on each end of
the units and into brackets on the
machine frame and the load.
The mounting pins must be parallel
to each other as shown in Figure 1.
Pins, which are not parallel to each
other, may cause the actuator to
bend and be damaged.
The load should act along the stroke
axis of the actuator since off centre
loads may cause bending and lead to
premature failure. See Figure 2.
axis of the actuator since off centre
loads may cause bending and lead to
premature failure. See Figure 2.
Make sure the mounting pins are
supported in both ends. Failure to
do so could shorten the life of the
actuator. Cantilever mounts are
unacceptable.
supported in both ends. Failure to
do so could shorten the life of the
actuator. Cantilever mounts are
unacceptable.
Figure 1
Figure 2
X
X
RIGHT
WRONG
WRONG
Warning!
If the actuator is used for pull in an application where personal
injury can occur, the following is valid:
If the actuator is used for pull in an application where personal
injury can occur, the following is valid:
It is the application manufacturer’s responsibility to incorporate a suitable
safety arrangement, which will prevent personal injury from occurring, if
the actuator should fail.
safety arrangement, which will prevent personal injury from occurring, if
the actuator should fail.
Warning!
LINAK’s actuators are not constructed for use within the following
fields:
LINAK’s actuators are not constructed for use within the following
fields:
• Offshore installations
• Aeroplanes and other aircraft
• Explosive environments
• Nuclear power generation
• Aeroplanes and other aircraft
• Explosive environments
• Nuclear power generation
10