Garmin stylus pro pro 4900 Manuale Utente

 Align the cutter cover, then press it in until it snaps

into place.

 Replace the front cover.

 If you are using the optional SpectroProofer, 

install it without replacing the front cover.

Close the printer cover and ink cartridge covers.

The Epson Stylus Pro 4900 has two maintenance tanks:
Ink (part# T619000) and Borderfree (part# T619100).
You need to replace each maintenance tank when the LCD
screen instructs you to do so.

 Check the LCD screen to determine which tank needs

to be replaced (Ink or Borderfree).

  The printer will not print if one of the 

maintenance tanks is full.

 Turn off the printer.

 Open the right ink cartridge cover.

 Pull out the maintenance

tank as shown.

 Do not tilt the 

tank or ink may spill out

 Place the used tank in the plastic bag included with

the new tank and dispose of it carefully.

 Insert the new tank, then close

the cartridge cover.

 Open the cutter cover.

 Loosen the screw holding the cutter in place, then

carefully remove the cutter.

 The blade is sharp. Be careful when 

removing it.

Insert the new cutter. Make sure the cutter pin goes
into the hole. Tighten the screw using a cross-head
screwdriver.

 Remove the output tray.

 If optional 

SpectroProofer is 
installed, remove it.

 Release the tank lock.

 Pull out the maintenance

tank as shown.

 Do not tilt the 

tank or ink may spill out.

 Place the used tank in the plastic bag included with the

new tank and dispose of it carefully.

 Insert the new tank. Push

it in firmly.

 Set the lock, then replace

the output tray.

 The printer will not 

print if the tank is unlocked.