Nero nerovision express 3 Manuale Utente

 

Q: When I burn a disc, I get buffer underruns every time. 

A: There could be for several reasons for this.  

Please try the following: 
1.  Try reducing the burn speed of the recorder. 

2. Try different media brands. The one that you are using may not be compatible 

with your recorder. 

3. Update the firmware version on your recorder. Firmware is a chip inside your 

recorder, which acts as the brain of the device. Please check the manufacturer’s 
website for the latest version. 

4.  Recorder or cable that is attached to it is defective. 
5.  Try using a different source to see if it is corrupted or too slow as a source. 

6.  Defrag your hard disk from time to time. 

7.  During burning no other tasks should be performed by the computer. 
8. Before burning, you should always run the speed test and the simulation 

in order to get the optimal speed. If not, the maximum possible write speed of 
the recorder is kept as default. 

9. Proceed to the Nero homepage to check for software updates at 

   

Q: I have installed NeroVision Express 3 correctly but it still will not see my 
recorder? 
A: There are a number of possible causes: 

The recorder is either too old and support for this drive has been discontinued  

The recorder is very new to the market and support has not yet been implemented 
or is the process.  

Please check to make sure that your PC recognized the recorder and that it has 
been installed properly. You can go to Start > Control Panel then the appropriate 
menu to see if your hardware was installed correctly or not. 

 

 

Please check the Nero website at www.nero.com for the latest drivers, updates 
and a list of supported recorders. 
 

 

•  99