Manualsbrain.com
  1. Manuali
  2. Marche
  3. kussmaul
  4. 091-32
  5. Manuale Utente

kussmaul 091-32 Manuale Utente

Scarica
Pagina di 9
CAUTION
There are 5 switches, each with 5 levers.
Only one lever on each switch may be
in the “ON” position.
 NOTE
The LOAD MANAGER is designed to operate relays.  It is not necessary
The LOAD MANAGER is designed to operate relays.  It is not necessary
The LOAD MANAGER is designed to operate relays.  It is not necessary
The LOAD MANAGER is designed to operate relays.  It is not necessary
The LOAD MANAGER is designed to operate relays.  It is not necessary
to connect to all outputs.  Any outputs, at the discretion of the installer,
to connect to all outputs.  Any outputs, at the discretion of the installer,
to connect to all outputs.  Any outputs, at the discretion of the installer,
to connect to all outputs.  Any outputs, at the discretion of the installer,
to connect to all outputs.  Any outputs, at the discretion of the installer,
may remain unused.  Nothing should be connected to the unused
may remain unused.  Nothing should be connected to the unused
may remain unused.  Nothing should be connected to the unused
may remain unused.  Nothing should be connected to the unused
may remain unused.  Nothing should be connected to the unused
outputs.  Relays must have a coil resistance of 40 ohms or greater.
outputs.  Relays must have a coil resistance of 40 ohms or greater.
outputs.  Relays must have a coil resistance of 40 ohms or greater.
outputs.  Relays must have a coil resistance of 40 ohms or greater.
outputs.  Relays must have a coil resistance of 40 ohms or greater.
DO NOT LOAD ANY OUTPUT WITH A RELAY WITH A
DO NOT LOAD ANY OUTPUT WITH A RELAY WITH A
DO NOT LOAD ANY OUTPUT WITH A RELAY WITH A
DO NOT LOAD ANY OUTPUT WITH A RELAY WITH A
DO NOT LOAD ANY OUTPUT WITH A RELAY WITH A
RESISTANCE LESS THAN 40 OHMS
RESISTANCE LESS THAN 40 OHMS
RESISTANCE LESS THAN 40 OHMS
RESISTANCE LESS THAN 40 OHMS
RESISTANCE LESS THAN 40 OHMS
Each switch controls the operation of a relay.  The actuation sequence of a
particular relay is controlled by the individual levers of each switch.  Lever #5 is
the lowest priority, while lever #1 is the highest.  It is thus possible to arrange the
relay operating priority for the 5 lowest priority relays.