dallee-electronics steam chuff version 3 Manuale Utente
3
DC track power installation using standard batteries & DALLEE controller #755
*Larger motors require a larger capacity choke.
Choke's available:
Item 702 - 1.5 ampere loads
Item 703 - 5.0 ampere loads
Item 703 - 5.0 ampere loads
Battery power - must not exceed 24 volts DC.
Use one 9 volt battery or a string of 6 AA or
Use one 9 volt battery or a string of 6 AA or
AAA batteries (24 volt DC maximum input). Life
depends on volume setting and speaker
impedance. Typical operation of most sound
systems for one good 9 volt batteries is about 8
hours, AA or larger is well beyond 50 hours!
hours, AA or larger is well beyond 50 hours!
wires with a " " ARE a
connection!
wires crossing over
(without a " ")
DO NOT CONNECT!
CHOKE *
DC
motor
Battery Holders
#579 - single 9 volt (shown)
#652 - holds 6 AA
#654 - holds 2 AA
#578 - 9 volt battery snap
connector
ON / OFF
switch
+
–
speaker
Red
Red
Gray
9V or 6-AA,
or 6-AAA
batteries
–
+
Left Rail
Pickup
Right Rail
pickup
CHOKE PACK
for additional chokes order:
Item 702 for up to 1.5 ampere load
Item 703 for up to 5.0 ampere load
Item 703 for up to 5.0 ampere load
LOAD
Formerly right
rail pickup
CHOKE
looks like coil of wire with a
lead on each end
either rail may be
used. Right / Left
only used for
reference.
only used for
reference.
Lighted car / other engines used in consist preperation. You will know if this is necessary
by placing the locomotive / lighted cars on the track and then attempting to blow the
Whistle or operate the BELL. If they do not operate with the other items on the track
then you need to do the following. We suggest doing this to all lighted cars or
engines used in the same consist since it lets the signal stay at it's maximum level.
then you need to do the following. We suggest doing this to all lighted cars or
engines used in the same consist since it lets the signal stay at it's maximum level.
Lighting load, other locomotive in
consist, or other type circuitry
drawing off of track power. As
shown one lead needs to be
disconnected from the rail and a
"CHOKE" needs to be placed in
series with the load. In most cases
the 1.5 ampere (#702) will handle
the load.
drawing off of track power. As
shown one lead needs to be
disconnected from the rail and a
"CHOKE" needs to be placed in
series with the load. In most cases
the 1.5 ampere (#702) will handle
the load.
Left Rail
pickup
either rail may be used. Right / Left
only used for reference.
Right Rail
pickup
lighting
circuits
to optional chuff
sound settings
Chuff Pitch: (J4)
connect from: 1 (red) 2 (gray)
to: J2 - 2 (gray)
lowest pitch
no
no
higher pitch
yes
no
higher pitch
no
yes
highest pitch
yes
yes
#524 DPST switch.
Switch shown in the OFF position.
Drawn as a SPST.