buzz-tools buzzsize Manuale Utente

BuzzSize

™

Basics

•

Each section starts with a Section Break flag and is followed by a
description of the section. You may need to zoom in on an area of the
Stitches-in-Time

window before you can read these descriptions (see

“Zooming In Time” on page 19).

Select by Double-Clicking

To select an entire section, just position your

cursor between two section flags and double-click. Your selection will
snap to these boundaries. You can click directly on top of the descriptive
text.

Select by Dragging

If you click near the beginning of a section, the

selection will “snap” to the beginning of the section. If you click near the
end of a section, the selection will “snap” to the very end of the section.

Selecting a Single Long Stitch

To select a single long stitch, first click on the long
stitch in the Stitches-in-Time

window

(Figure 2-12). This will select the first needle point
of the stitch. Then hold down the shift key and press
the right arrow key to select the stitch itself. You can
then travel through the design one stitch at a time by
using the forward and back arrow keys.

Adjusting Your Selection

You can adjust the starting and ending stitches of a
selection by using the arrow keys, much as in a text editor.

NOTE Multi-Hoop designs are not supported by BuzzSize. If you need multi-hoop
support you will need to purchase

BuzzEdit

V2.

Desired Action

Do the Following

To adjust the first stitch of a
selection
(marked by a small box in the
Stitches-in-Space window)

Hold down the control key and press the left or
right arrow keys.

OR hold down the control key and click the
mouse in the Stitches-in-Time

window.

Figure 2-12 Click
near a long stitch
to select its needle
point.