dhi replacement power supply kit for rpm3 or molbox rfm installation instructions Manuale Utente
RPM3 and molbox RFM are trademarks, registered and otherwise, of DH Instruments, Inc.
Document 560047
020724
DH Instruments, Inc.
4765 East Beautiful Lane
Phoenix AZ 85044-5318
USA
Phoenix AZ 85044-5318
USA
Tel 602.431.9100
Fax 602.431.9559
dhi@dhinstruments.com
www.dhinstruments.com
INSTALLING THE NEW POWER SUPPLY:
n
Install the new plastic standoff into the new power
supply.
Position the power supply in the correct mounting
location with the plastic standoff directly above the
mounting hole on the main board.
mounting hole on the main board.
Press down on the power supply to captivate the
plastic standoff to the main board.
Install a nylon washer between the power supply and
the metal mounting tab, two (2) places, (see Figure 3).
Install the new nylon screw and stainless steel screw
and lockwasher at the correct locations (see Figure 3).
Figure 3 Left Side View
1. Screw, SS, M3 X 8
2. Nylon Washer (2 ea.)
and Lockwasher, SS, M3 3. Screw, Nylon, M3 X 12
Reattach DC and AC cables.
Place chassis into enclosure base.
Assemble enclosure cover to base by first
reconnecting the fan cable, then close cover and
install cover screws.
install cover screws.