dhi note for users of new molbox1 with existing molblocs Manuale Utente
Document 560014
990901
DH Instruments, Inc.
4765 East Beautiful Lane
Phoenix AZ 85044-5318
USA
Phoenix AZ 85044-5318
USA
Tel 602.431.9100
Fax 602.431.9559
dhi@dhinstruments.com
www.dhinstruments.com
Calibration Solutions
for Pressure
and Flow™
NOTE FOR USERS OF NEW
molbox1™
WITH EXISTING molblocs™
If you are going to be using this new molbox1 with previously delivered molblocs, there is the possibility that
the molbloc temperature measuring circuit is not compatible with the new molbox1.
To check compatibility, turn on the molbox1 with the molbloc connected. If the molbox1 autotests and goes
to the main run screen normally, the molbloc is compatible with the molbox1. If you encounter the message
"PRT ERROR", the molbloc is not compatible with the molbox1. If used, it may give out of tolerance
flow indications.
If you observe a "PRT ERROR" message when initializing a molbloc, contact DHI Technical Service for
information on upgrading the molbloc for compatibility.
information on upgrading the molbloc for compatibility.
molbox1 and molbloc are trademarks of DH Instruments, Inc.