ge-interlogix simon 3 Manuale Utente

Press Test three times to perform a DL phone test.

4.

Press DONE. The panel confirms that a phone test or downloader phone test has 
begun. When the phone test is complete, the panel will announce Phone Test is OK 
within 3 minutes. The panel will say Phone test is on three times if you have a 
pager. Your pager will display 101 101 if the phone test to the pager was successful. 

If the test is unsuccessful, the SYSTEM STATUS button will light and the panel will 
say Phone communication failure within 10 minutes.

If the panel announces Phone communication failure, proceed to the following instruc-
tions.

¾

1.

Check that the panel is connected to the phone jack.

2.

Check the phone number programmed into the panel. 

3.

Perform the phone test again.

4.

If the phone test fails again, check the phone connection wiring.

* Not investigated for use by UL.

Test the system from a remote phone by calling the panel and using the commands in 
the following table.

After performing sensor and phone tests, check that the system is reporting alarms suc-
cessfully to the central station.

¾

1.

Call the central station and tell the operator that you will be testing the system.

2.

Arm the system.

3.

Test each of the wireless panic buttons and trip at least one sensor of each type 
(fire, intrusion, etc.) to verify that the appropriate alarms are working correctly. 

DISARM

* + CODE + 1

ARM Doors/Windows

* + CODE + 2

ARM Motion Sensors

* + CODE + 3

ARM Doors/Windows with No Entry Delay

* + CODE + 2 + 2

ARM Motion Sensors with Latchkey

* + CODE + 3 + 3

ARM Doors/Windows and Motion Sensors

* + CODE + 2 + 3

ARM Doors/Windows with No Entry Delay 

and Motion Sensors with Latchkey

* + CODE + 2 + 2 + 3 + 3

Toggle Lights

* + CODE + 0

System Status

* + CODE + # + 1

Audio Verification

* + CODE + 5 + X (X = a command from 

Audio Verification Set)

Terminate Session

* + CODE + 9