Cooler Master Cool Drive 6 LHD-V06 Manuale Utente
Codici prodotto
LHD-V06
CoolDrive 6
3. Connect the 4-pin Molex connector to the free
power connector on the CoolDrive 6 device’s
power supply unit (PSU).
power supply unit (PSU).
4. There are 4 black wires connected to the
CoolDrive 6 device. These are thermal sensors
and are labeled as CH1, CH2, CH3 and CH4.
Choose any flat surface on a device to be
monitored (for example, the surface of a hard
drive) and attach a thermal sensor to monitor its
temperature. Repeat this step for each additional device.
and are labeled as CH1, CH2, CH3 and CH4.
Choose any flat surface on a device to be
monitored (for example, the surface of a hard
drive) and attach a thermal sensor to monitor its
temperature. Repeat this step for each additional device.
5. There are 4 fan cables that connect to the CoolDrive 6 device. They are labeled
FAN1, FAN2, FAN3 and FAN4.
Note: FAN3 cable is reserved for the fan that comes with CoolDrive 6 and was
assembled by factory.
Each cable has 3 wires. The red wire is for power (+12V DC). The black wire is for
grounding. And the yellow wire is for fan speed detection. If you want to connect a cable
to a fan than only has 2 wires, identify the grounding wire first. In general, a fan’s
grounding wire is black.
assembled by factory.
Each cable has 3 wires. The red wire is for power (+12V DC). The black wire is for
grounding. And the yellow wire is for fan speed detection. If you want to connect a cable
to a fan than only has 2 wires, identify the grounding wire first. In general, a fan’s
grounding wire is black.
6