Panasonic KX-P8420 Guida Al Funzionamento
118
Setup from the Front Panel and WebSetup
■
Protocol Setup tab
The options that you can set from the Protocol Setup tab are described
below.
below.
The KX-P8420 can accept jobs via TCP/IP (over either Ethernet or Token
Ring), AppleTalk, and IPX/SPX simultaneously. To configure the KX-P8420,
choose each protocol and enter the settings for that protocol.
Ring), AppleTalk, and IPX/SPX simultaneously. To configure the KX-P8420,
choose each protocol and enter the settings for that protocol.
Enable Ethernet or, if you have enabled and installed the Token Ring option,
enable Token Ring. If your network uses a gateway, enter the gateway
address.
enable Token Ring. If your network uses a gateway, enter the gateway
address.
Enable on Ethernet—Enable this option if you have a TCP/IP network
connected to the KX-P8420 over Ethernet cabling.
connected to the KX-P8420 over Ethernet cabling.
You must enable TCP/IP for Ethernet to use the Fiery WebTools over
Ethernet.
Ethernet.
IP Address—Enter the KX-P8420 IP address for Ethernet. The KX-P8420
is shipped with the IP address set to the loopback address (127.0.0.1),
is shipped with the IP address set to the loopback address (127.0.0.1),
which is an internal address used for network checking. If you plan to print
with TCP/IP, you must first assign the KX-P8420 a unique network IP
address. For information about setting up printing with TCP/IP, see
with TCP/IP, you must first assign the KX-P8420 a unique network IP
address. For information about setting up printing with TCP/IP, see