Panasonic KXHNS107 Guida Al Funzionamento
Securing with screws
Important:
R Make sure the screws are shorter
R Make sure the screws are shorter
than the thickness of the installation
surface.
surface.
1
Remove the sensor from the
mounting adaptor by pressing the
release lever (A), sliding the
sensor up and lifting it away from
the mounting adaptor (B).
mounting adaptor by pressing the
release lever (A), sliding the
sensor up and lifting it away from
the mounting adaptor (B).
A
B
2
Use the screws to attach the
mounting adaptor to the inside of
the garage door.
R Make sure the “UP” mark on
mounting adaptor to the inside of
the garage door.
R Make sure the “UP” mark on
the mounting adaptor points
upwards when the garage door
is closed.
upwards when the garage door
is closed.
UP
UP
A
25.4 mm (1 inch)
3
Attach the sensor to the mounting
adaptor.
adaptor.
R The sensor will click into place
when it is secured.
R Make sure the “UP” marks on
the back of the sensor and the
inside of the mounting adaptor
point in the same direction.
inside of the mounting adaptor
point in the same direction.
For assistance, please visit http://shop.panasonic.com/support
15
Setup
HNS107_(en_en)_1210_ver.031.pdf 15
2015/12/10 16:49:07