Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16 Guida Specifiche
20
Route Switch Processor (RSP16) Installation and Configuration Guide
OL-4661-03
Installing the RSP16
Restarting the System
When you turn the system power back on, verify that the system boots and resumes normal operation. If
you are restarting the system after upgrading the DRAM, expect that it will take the system longer to
complete the memory initialization portion of the boot sequence with more DRAM. (See the
you are restarting the system after upgrading the DRAM, expect that it will take the system longer to
complete the memory initialization portion of the boot sequence with more DRAM. (See the
Follow these steps to verify that the RSP16 is installed and functioning properly:
Step 1
Check the RSP16 connections to make sure they are secure:
•
The RSP16 is inserted all the way into its slot, and both captive installation screws are tightened.
•
The console terminal is turned on and is connected to the console port.
Step 2
Observe the RSP16 LEDs. While the system initializes, the CPU halt LED on the RSP16 stays on. It
goes off when the boot process is complete. As the RSP16 initializes each interface processor, the status
LEDs on each interface processor go on and off in irregular sequence.
goes off when the boot process is complete. As the RSP16 initializes each interface processor, the status
LEDs on each interface processor go on and off in irregular sequence.
Step 3
For a Cisco 7507, Cisco 7507-MX, Cisco 7513, or Cisco 7513-MX with HSA or HA configured, verify
that the console terminal displays the system banner and startup screen as the system restarts.
that the console terminal displays the system banner and startup screen as the system restarts.
•
The active console display should look similar to the following for a Cisco 7513 and Cisco 7513-MX
(note the RSP slots indicated):
(note the RSP slots indicated):
System Bootstrap, Version 12.0(20011126:200409) [biff-RSP16_BENGAL_120S 251], DEVEL
OPMENT SOFTWARE
Copyright (c) 1994-2001 by cisco Systems, Inc.
SLOT 6 RSP is system master
RSP16 platform with 262144 Kbytes of main memory
rommon 1 > b
Self decompressing the image :#######################################################
######################################################################################
########################################################################## [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-PV-M), Experimental Version 12.1(20020307:194032) [biff-
121E_LATEST 127]
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Fri 26-Apr-02 16:52 by biff
Image text-base:0x60010958, data-base:0x611A4000
cisco RSP16 (R7000A) processor with 262144K/8216K bytes of memory.
R7000 CPU at 400Mhz, Implementation 39, Rev 3.3, 256KB L2, 2048KB L3 Cache
Last reset from power-on
G.703/E1 software, Version 1.0.