Cisco 7000 SERIES PA 8 PORT T1 MC ADAPTER WITH CSU DSU Guida Specifiche
4-8
Multichannel DS1/PRI Port Adapter Installation and Configuration
OL-3525-03
Chapter 4 Configuring the Multichannel DS1/PRI Interfaces
Configuring the Interfaces
Note
The channel-group number can be from 0 to 23 and the time slot value can be from 1 to 24.
Step 7
Enter the description line up to 80 characters describing this controller configuration subcommand to
set the description, as in the following example:
set the description, as in the following example:
Router(config-controller)# description Arizona 3 Router; location: building 2
Step 8
Enter the cablelength {long [gain26 | gain36] [0db | -7.5db | -15db | -22.5db]} configuration
subcommand to set the cable length, as in the following example:
subcommand to set the cable length, as in the following example:
Router(config-controller)# cablelength long gain26 -15db
Enter the no form of this command to restore the default, gain36, 0dB.
For the PA-MC-8DSX1 port adapter, set the cable length by entering the cablelength {short [133 |
266 | 399 | 533 | 655]} command, as in the following example:
266 | 399 | 533 | 655]} command, as in the following example:
Router(config-controller)# cablelength short 266
Use the no form of this command to return to the default, 133. The range of values for the short-haul
cable lengths is from 0 to 655 feet.
cable lengths is from 0 to 655 feet.
Step 9
Enter the fdl {att | ansi} configuration subcommand to set the Facilities Data Link (FDL), as in the
following example:
following example:
Router(config-controller)# fdl ansi
Use the no form of this command to disable FDL.
Note
The fdl configuration subcommand is not allowed in SF mode.
Step 10
Enter the shutdown configuration subcommand to shut down the controller, as in the following
example:
example:
Router(config-controller)# shutdown
To exit controller configuration mode and return to global configuration mode, enter the exit command.
To exit configuration mode and return to privileged EXEC mode, use the end command or press Ctrl-Z.
To exit configuration mode and return to privileged EXEC mode, use the end command or press Ctrl-Z.
Configuring the Interface
The following steps make up a basic interface configuration for the multichannel DS1/PRI port adapter:
Step 1
At the privileged-level prompt, enter configuration mode and specify that the console terminal will be
the source of the configuration subcommands:
the source of the configuration subcommands:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Step 2
Specify the interface to configure by entering the interface serial subcommand, followed by the
interface address of the interface you plan to configure.
interface address of the interface you plan to configure.
provides examples.