Wet Sounds STX Micro 4 Manuale Proprietario

CONNECTIONS – STX MICRO-4

6

BEFORE ANY INSTALLATION IS BEGUN – DISCONNECT THE BATTERY!
8. Power (RED) Connection. It is recommended that the power connection 

be run directly to the vehicle’s battery. Run a minimum 8 Gauge wire with 
a fuse at the battery. Be sure that the outboard dual ATC fuse holder stays 
close to the amplifier. FAILURE TO USE THE SUPPLIED OUTBOARD FUSES IN 
THE INSTALLATION IS DANGEROUS AND WILL VOID THE WARRANTY!

9. Ground (BLACK) Connection. This should be connected to chassis ground 

where possible. If the vehicle does not have a chassis ground, run a wire 
directly to the negative side of the battery.

10. Remote Turn-On (BLUE) Connection. This should be connected to a wire 

that supplies +12V when powered on. The BLUE wire must receive +12V 
for the amplifier to power on.

11. Speaker Connections. Speaker connection color codes are as follows:

Front Left Positive Speaker  

White (Bridged Front +)

   

Front Left Negative Speaker  

White / Black

   

Front Right Positive Speaker  

Grey

   

Front Right Negative Speaker  

Grey / Black (Bridged Front -)

   

Rear Left Positive Speaker 

Green (Bridged Rear +)

   

Rear Left Negative Speaker  

Green / Black

   

Rear Right Positive Speaker  

Violet

   

Rear Right Negative Speaker  

Violet / Black (Bridged Rear -)

12. Front and Rear Inputs. Connect to the output of the source unit or BT 

controller. These connectors are designed to accept a 3.5mm male plug. 
An RCA style adaptor such as the Wet Sounds WW-RCA-3.5mm 2ft can be 
used if the source has RCA style connectors.

13.Pass Through Output. Use this output if you need to feed signal to the 

input on an additional amplifier – such as the STX MICRO-1 or a Wet 
Sounds ST-AS10/AS6 amplified subwoofer. This will pass the same signal 
that is present at the front input, avoiding the need for any Y adaptors.