Brandmotion 9002-8847 Manuale Proprietario
8847 Instructions 1-29-15.docx
Page 1 of 6
Jeep Wrangler Adjustable Rear Vision
System for Factory Display Radios
,
2007 – Current (Kit # 9002-8847)
Items Included in the Kit
Camera
Chassis Harness
Power Harness
Jumper Harness
Program Module
Zip lock bag with 15 Wire Ties & 3 Push Nuts
Camera Extension Bracket
White 22-pin Radio Connector
Chassis Harness
Power Harness
Jumper Harness
Program Module
Zip lock bag with 15 Wire Ties & 3 Push Nuts
Camera Extension Bracket
White 22-pin Radio Connector
These Instructions
Required Tools & Supplies
T15 & T20 Torx Bits
7mm & 10mm Sockets
Phillips Screwdriver
3/8” Wrench or Socket Drive
Plastic Trim Removal Tool
Soldering Iron, Solder, & Heat Shrink Tubing
7mm & 10mm Sockets
Phillips Screwdriver
3/8” Wrench or Socket Drive
Plastic Trim Removal Tool
Soldering Iron, Solder, & Heat Shrink Tubing
(RECOMMENDED) or T-taps as an alternate
splicing method
splicing method
Electrical Tape
Install Camera
Step 1: Loosen lug nuts to remove spare tire.
Step 2: Slide Camera on studs placing harness end
inside of tire carrier.
inside of tire carrier.
Step 3: Adjust Camera head to fit your specific wheel.
Bracket is shipped in factory wheel configuration.
Bracket is shipped in factory wheel configuration.
Adjustment Bracket for Camera Clearance using Phillips
Screwdriver and 3/8” Wrench or Socket Drive
Screwdriver and 3/8” Wrench or Socket Drive
Note: Short Bracket has been designed for Factory
offset wheels. Use the Long Bracket for wheels with
larger offsets.
offset wheels. Use the Long Bracket for wheels with
larger offsets.
Step 4: Remove spare tire and slide (3) supplied Push