Brandmotion FDMC-1241 Manuale Proprietario

1241 Instruction 3-6-15

Page 1 of 6

2015 Toyota Camry Qi Wireless Charging Kit

(Kit # FDMC-1241)

Please read thoroughly before starting installation and check that kit contents are complete.

Items Included in the Kit:

Tools & Supplies Needed:

Qi Wireless Charging Module with

Camry Specific Mat

Power Harness with 3 amp Fuse
4 – Flat Head Torx 1/2" Screws
These Instructions with Template
Removable Consumer Product Label

Plastic Trim Removal Tool

T-15 Torx Driver
Phillips Screwdriver
Center Punch/Scribe Tool
Power Drill
1/8”, 3/16’’ and 1/4” Drill Bits

Wire Ties
Soldering Iron & Solder

(Recommended)

Tape or Heat Shrink Electrical Tubing

*Note this product is designed to work with Qi compatible devices. Please confirm that
your device is Qi compatible before installation. Visit

www.brandmotion.com

for phone

compatibility guide.

Safety Precautions:

• Work in well ventilated area that is clear of obstructions.

• Secure vehicle with tire chucks in both front and rear of tires.

• Turn vehicle accessories OFF and ensure ignition key is in OFF position.

• Wear safety goggles and snug fitting clothes.

• Use tools only for their intended purpose and which are in good repair.

• Only perform this task if confidence, skill, and physical ability permit.

NOTE: We strive to provide accurate and up-to-date installation instructions.

For additional assistance please call Brandmotion Technical Assistance at (734) 619-1250 then dial 2.

IMPORTANT: Do not place smart keys
within 15cm of charging mat. Vehicle
may not detect key to start vehicle. Do
not place metal objects in tray while
charging.