Exegin Technologies Limited Q53 Manuale Utente

69

Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2009

However, the Zigbee gateway bridge device also uses TCP access lists to restrict host 
connections with the device and allows scrambling/descrambling of print jobs.

The Q53 supports two users:

Access to everything within the Zigbee gateway bridge device including 
all configurable settings.

Ability to list settings but not configure them.

For each user, a password can be set. However, you would normally only set a password 
for the root user to protect the Q53’s configuration. Guest users cannot alter the Zigbee 
gateway bridge device’s configuration in any way.

To configure the root password on your Q53, you will need to:

1. Load a Web browser on a network station that can communicate with the Zigbee 

gateway bridge device over TCP/IP. 

2. Direct your Web browser to URL "

" 

(e.g. "

").

If prompted for a "User ID" and password first, type in "

" for the ID and 

press ENTER at the password prompt as there is no password by default.

3. Click within the "Old" field beside the "Root Password" heading and enter the 

existing root password. By default, there is no root password; in this case, this step 
can be skipped.

4. Within the "Root Password" section, click within the "New" field and enter the new 

root password.

5. Within the "Root Password" section, click within the "Confirm" field and enter the 

new root password again. Remember this the password is case sensitive.

6. Click on the "Submit" button when done.

7. Go to the Restart page and click on "Restart" to apply the new settings to your 

system.

1. Start a Telnet session with the Q53. Type:

2. Login to the Q53 through a command line shell session as a root user.

If prompted for a "User ID" and password first, type in "

" for the ID and 

press ENTER at the password prompt since there’s no password by default.

3. At the command shell prompt, follow this syntax:

set user passwd username password

For example, to set the root password to "mplex1" type: