Exegin Technologies Limited Q53R6 Manuale Utente
16
Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2013
3. Installing the Q53
Connecting the Q53 to a Network
Connecting the Q53 to a Network
Two LED indicators are used to indicate Ethernet link integrity (see
LED at the bottom left of the UTP network connector will be illuminated when a 100
MB/S link is established over the network connection, or extinguished otherwise. The
red LED at the bottom right of the UTP network connector will be illuminated when a
10 MB/S link is established over the network connection, or extinguished otherwise.
MB/S link is established over the network connection, or extinguished otherwise. The
red LED at the bottom right of the UTP network connector will be illuminated when a
10 MB/S link is established over the network connection, or extinguished otherwise.
Figure 3—Q53 Top View: LED Status Indicators
Watch the LED indicators on the top panel as they cycle through the power-on self-test.
When the test is complete, the STAT LED will flash once per second or, if there is no IP
address configured, twice per second (see
When the test is complete, the STAT LED will flash once per second or, if there is no IP
address configured, twice per second (see
on page 18 for instruction on how to
configure an IP address).