Axiometric LLC GW2C-AC Manuale Utente

Axiometric Gateway Guide

 

 

 

The Gateway 2 requires an external AC (110-220VAC 
50/60Hz) or DC (POE or Solar) power source and should be 
mounted in a location with convenient access to power.   
 
When using solar power, the solar panel should be angled 
towards the sun in the South to gather maximum energy.   
 
When using Power Over Ethernet (POE), the DC source 
voltage should be adjusted based on the length of the Ethernet 
cable to deliver approximately 12vdc to the Gateway 2.  An 
un-interruptible power source (UPS) should be used with the 
POE DC power source at the injector. 

 

Based on the network bridge function selected (Ethernet, WiFi, POTS, or Cellular), the 
gateway should be mounted with clear access to the remote network.  For example, a 
Gateway 2 with WiFi bridge option should be mounted with an unobstructed view of the 
WiFi access point it will communicate with; similarly, a Gateway 2 with Cellular bridge 
option should be mounted with an unobstructed view of the cell tower it will 
communicate with. 

 

Once configured and mounted, the following steps should be followed to start Gateway 
2 operation: 

 

1.  With external power disconnected 

remove the four bolts that secure the 
Gateway 2 front panel; carefully 
remove the panel and install a UM-1 
lithium battery (Tadiran Pulses Plus 
recommended) in the battery clip on 
the right side of the gateway. 
Connect the battery connector to the 
Gateway 2 main board header JP3 
observing the polarity of the header. 
The LEDs on the Gateway 2 Mesh 
Stamp should illuminate and begin 
blinking.