Shenyang Torch-Bigtide Digital Technology Co. Ltd. 19LCD1928M Manuale Utente
Last change:
2012-3-1
2012-3-1
User Manual
HL1928M-L/R
Page 12 of
32
4.1.3 Little cover (attaching)
Lead the monitor end of the cables through the little cover’s cable duct.
Connect the little cover to the rear cover
.
4.2 Power up the display
Power up the display and the operation LED lights up (color: green, provided the
timing has been recognized – please refer to section 7 "Fault diagnostics").
timing has been recognized – please refer to section 7 "Fault diagnostics").
4.3 Adjusting the image geometry
The display automatically recognizes the used standard, and set-up values for
each standard are preprogrammed. However, depending on the graphics card
used, it may still be necessary to align and size the picture for the selected
standard (see Section 6.1 "Picture adjustment"). Normally auto adjust will work.
each standard are preprogrammed. However, depending on the graphics card
used, it may still be necessary to align and size the picture for the selected
standard (see Section 6.1 "Picture adjustment"). Normally auto adjust will work.
4.4 Adjusting the brightness and contrast
The brightness and contrast must be adjusted for the respective graphics card
(different output levels) in the system on site.
(different output levels) in the system on site.
Note on adjustment
− Use the SMPTE test pattern.
− Adjust the brightness so that image sections with 5% and 0% blackness still
visibly contrast from one another.
visibly contrast from one another.