System Planning Corporation GTLITEV3 Manuale Utente
GlobalTrak ™
GT Lite Operation and Maintenance Manual
3.2 Updating Main Processor Firmware
Firmware Update Procedure
In the rare event that the main processor firmware requires an upgrade, below is the
procedure to do so.
1. Download and install DWLWin from the Sierra Wireless if it is not already done.
2. Put your board in bootloader mode by jumpering J5 (shown below in Figure XXXXX) and
putting J29 in Programming mode as shown in Figure XXXXXXX above.
Figure XXXXXXXX
3. Connect the GT Lite debug cable to the external Conxall connector. Connect the serial
(RS232) end of the debug cable to a PC.
4. Power GT Lite on.
5. Open DWLWin and set it to the correct COM port and 115,200 baud.
6. Point the “Working Dir” at the .wpk firmware file, and check the .wpk checkbox.
7. Check “Open AT Application” under Erase.
8. Click Start in DWLWin, and then hold down switch S1 (shown in Figure XXXXX) on the
board until the whole process is done. When prompted, select the chip as Q2687g. In all
other dialog boxes, respond with NO.
other dialog boxes, respond with NO.
Figure XXXXXXX
Firmware Versioning Information
Some changes in main processor firmware require modifications in the application software
making only certain application software versions compatible with certain firmware versions.
making only certain application software versions compatible with certain firmware versions.
Below is the compatibility list.
FW Version
SW Version
Description
663b10
2.X
Original software. ATT compatible. FW and SW
will become obsolete.
R72a00
3.X
Major upgrade. Adds slow idle capability. ATT
compatible. Toolset will become obsolete.
compatible. Toolset will become obsolete.
R74a00
Unknown (may be 3.X)
Latest firmware for use with new toolset. No EOL
plan set.
Prepared: R. Straz
Date: July 25, 2007
Page 48 of
139