System Planning Corporation GTLITEV3 Manuale Utente
GlobalTrak ™
GT Lite Operation and Maintenance Manual
Date: July 25, 2007
Page 90 of
139
6.2 Installation Types
Dry Goods Container Bracket
Note: Use of Dry Goods Container Bracket requires GT Lite internal door sensor.
Dry goods container bracket allows the GT Lite to be quickly and securely mounted to a
container door with almost no chance of error. By design, this configuration monitors door
container door with almost no chance of error. By design, this configuration monitors door
position along with the standard GT Lite sensors. The steps below pick up after steps 1-4 in
section 2.
section 2.
1. Install GT Lite to the Dry Goods Container Bracket using 4 #8 screws. (this step is likely
to be already completed)
2. Install the GT Lite bracket on the left door (as facing the container doors from the outside)
allowing the notched section to fit over a rib in the door. See figure 5.
Figure 5
3. Install the magnet bracket on the right door, again allowing the notched section to fit over
a rib in the door. See figure 6.
Figure 6
4. Close container doors.
Reefer Container Bracket
TBD
Prepared: R. Straz