Bently Nevada Inc. 18531001 Manuale Utente
Section 4 - Commissioning Process
19
4. Commissioning Process
Commissioning is a process used to form a wireless
mesh network using the components of the Essential
Insight.mesh wireless system. This is a pre-
installation step that is usually performed indoors in
an equipment room, or similar environment. This
process requires both the hardware and software
components.
mesh network using the components of the Essential
Insight.mesh wireless system. This is a pre-
installation step that is usually performed indoors in
an equipment room, or similar environment. This
process requires both the hardware and software
components.
Follow the commissioning steps shown below:
1. Attach power modules to the wSIMs and
Repeaters
2. Setup the Manager Gateway
3. Commission the wSIMs and Repeaters
4. The Common Join Key
5. Verify the operation
4.1 Attach Power Modules to wSIMs and
Repeaters
Repeaters
Attach the power modules to the wSIMs and
Repeaters so that they charge up for approximately
45 minutes prior to turning them on. The battery
power module is attached to a wSIM or Repeater
using six #6 socket head cap screws (SHCS) that are
integrated (captured) into the power module housing.
When connecting the battery power module, ensure
that the O-ring is in place on the top of the battery
module and that the interface pins on the bottom of
the wSIM or Repeater are lined up with the contacts
on the battery module. Tighten the screws using a
7/64 in. hex wrench.
Repeaters so that they charge up for approximately
45 minutes prior to turning them on. The battery
power module is attached to a wSIM or Repeater
using six #6 socket head cap screws (SHCS) that are
integrated (captured) into the power module housing.
When connecting the battery power module, ensure
that the O-ring is in place on the top of the battery
module and that the interface pins on the bottom of
the wSIM or Repeater are lined up with the contacts
on the battery module. Tighten the screws using a
7/64 in. hex wrench.