Essence Security International ltd. ES6500EGE Manuale Utente
Operation
24
EverGuard Express
3.14.2 Arm Status
Two “status” LEDs provide the Arm status information. The table below details the
Arm status indicators of the EverGuard Express control panel.
Arm status indicators of the EverGuard Express control panel.
Figure 6: Arm Status Indicators
Icon Status
Full Arm
Red
While the system is in arm state
Part Arm Day/Night
Red
While the system is in part arm state
Table 6: Arm Status Indicators
3.14.3 Arming the EverGuard Express System
According to how you set the arming function in section Programming the Arm
Function on page 21, you can arm or part-arm the EverGuard Express system.
Function on page 21, you can arm or part-arm the EverGuard Express system.
Note: When an incorrect PIN code is entered 5 consecutive times, the
EverGuard Express control panel sends an alert to the control center
EverGuard Express control panel sends an alert to the control center
To arm the EverGuard Express System:
1. If you configured the arm function to arm via the arm button only, press the
desired arm button.
- Full Arm
+ key number 1 or 2- Part Arm Day/Night
If you configured the arm function to require the master PIN code, using the
number keys, enter the master PIN code and then press the desired arm
button. Each key press is indicated by a single beep. The EverGuard Express
panel sounds a good beep to indicate that the PIN code is entered correctly
and then sounds a countdown beep.
number keys, enter the master PIN code and then press the desired arm
button. Each key press is indicated by a single beep. The EverGuard Express
panel sounds a good beep to indicate that the PIN code is entered correctly
and then sounds a countdown beep.
During the Arm process, the relevant numbers are lit to indicate which device
will be armed according to the definitions. In case of having more than 10 RF
security devices, a Digital Voice Keypad is essential. In that case, during Arm
process the numbers will not lit.
will be armed according to the definitions. In case of having more than 10 RF
security devices, a Digital Voice Keypad is essential. In that case, during Arm
process the numbers will not lit.
3.14.4 Disarming the System
The procedure for disarming the system is the same for all arm or part-arm
scenarios.
scenarios.
To disarm the system:
Using the number keys, enter a user PIN code. Each key press is indicated by
a single beep. The EverGuard Express panel sounds a good beep to indicate
a single beep. The EverGuard Express panel sounds a good beep to indicate