Phonetone Technology Co. Ltd. ANCP65 Manuale Utente

Pagina di 11
 
  5 / 11 
 
antenna is installed 
  The phone calls or data transmission shall be smooth and stable by 3 times testing 
in location where the outdoor antenna is to be installed 
  As shown from the above illustration, testing the signals from A to E, and select a 
best place that displays full bar signals to install the outdoor antenna. 
  Selecting the installation direction of outdoor antenna. 
  The outdoor antenna shall point to the direction of the tower, and it would be much 
better to keep line of sight. 
  Please select the opposite directions for outdoor antenna and indoor antenna. If 
outdoor  and  indoor  antennas  have  to  be  installed  in  the  same  direction,  please 
install them only after the signal quality is tested and the self-oscillation is avoided. 
If the directional antenna is selected, the main directional angle should point to the 
tower antenna. 
  If the performance is poor due to weak signals or poor phone call quality, please 
adjust the direction of outdoor antenna or change its position in order to obtain the 
best calling effect. 
  The wide band booster supports all mobile operators or different mobile systems, 
so please adjust the outdoor antenna direction to have balance between signals of 
different mobile operators or various mobile systems.   
  Connect the outdoor antenna to the booster connector marked OUTDOOR with 10 
meters 3D-FB Coaxial cable with N male connector 
Important : Outdoor antenna installation ---Notes: 
 
 
  In  order  to  avoid  interference,  please  note  that  the  outdoor  antenna  should  be  far 
away  from  the  following  objects  of  metal,  high-voltage  line,  RF  antenna  and 
high-voltage transformer. 
  Booster is a two-way signal  Booster. So proper isolation between  outdoor antenna 
and indoor antenna is necessary in order to avoid self-oscillation.   
  The minimum distance between outdoor antenna and indoor antenna shall be more 
than 10 meters; again the direction of outdoor and indoor antennas shall be opposite. 
  As shown in the below illustration, the booster the downlink signal 
r
 from the tower 
and send to the indoor antenna hereafter. If the distance between  outdoor antenna 
and indoor antenna is less than the required distance, the amplified signal 
R
 will go 
back  from  indoor  antenna  to  outdoor  antenna.  So  it  will  lead  to  self-oscillation  and 
reduce the coverage area, also the bad calling quality could happen at the same time, 
and the worse is that the mobile network could be influenced badly and the operators 
will finally come to shut off the booster system.