IDEMIA Identity & Security France MPHAC001A Manuale Utente
Section 3 : Installation Procedure
2015_2000007248-V1 - Draft
This document and the information therein are the property of Morpho. They must not be
copied or communicated to a third party without the prior written authorization of Morpho
27
June 2015
Step by step procedure
The recommended height for fixing of the terminal is 1.40m (top of the product).
For an optimal use the terminal must be installed in an area where the
lighting conditions are controlled. Avoid direct exposure of the sensor to
the sun light.
lighting conditions are controlled. Avoid direct exposure of the sensor to
the sun light.
Power supply from electrical source shall be switched off before starting
the installation.
the installation.
The strength of the attachment depends on the solidity of the wall on
which the terminal is mounted.
which the terminal is mounted.
To ensure water tightness, the pre-wired back door has to be attached to
the product with the 4 screws (refer to corresponding picture for process).
the product with the 4 screws (refer to corresponding picture for process).
Drilling the mounting holes
Figure 7: Drilling template
6
0
,1
m
m
Scale 1.0
Φ = 4mm
8
3
,3
m
m
7
,4
5
m
m
1
4
0
0
m
m
40mm min
Ø46mm max