IDEMIA Identity & Security France MPHAC001A Manuale Utente
Section 4 : Electrical Interface
2015_2000007248-V1 - Draft
This document and the information therein are the property of Morpho. They must not be
copied or communicated to a third party without the prior written authorization of Morpho
34
June 2015
Tamper Switch
Figure 13: Tamper switch wiring
3
Light Blue
Switch 1
Tamper switch contact
4
Pink
Switch 2
Strip on tamper switch
Operating principle for the switch
Product installed on the wall plate: switch enabled (contact closed).
Product opened (rear connectors accessible): switch disabled (contact open).
Nominal characteristics of switch block
Electrical characteristics: 100 mA at 30 VDC max (Resistive load) according to the
safety extra low voltage standard.
safety extra low voltage standard.
This MorphoAccess® SIGMA Lite Series terminal is part of security system;
it is customer’s responsibility to connect the tamper switch (contact) to
physical access controller, in order to detect unauthorized access to the
connector blocks.
it is customer’s responsibility to connect the tamper switch (contact) to
physical access controller, in order to detect unauthorized access to the
connector blocks.