IDEMIA Identity & Security France MPHAC001A Manuale Utente
Section 4 : Electrical Interface
2015_2000007248-V1 - Draft
This document and the information therein are the property of Morpho. They must not be
copied or communicated to a third party without the prior written authorization of Morpho
43
June 2015
Ethernet connection
Ethernet interface can be used to power the MorphoAccess® SIGMA Lite Series
terminal through POE (Power Over Ethernet - IEEE802.3af or IEEE802.3at type 1
mode). According to the POE standard two modes are available: power on data pins
and power on dedicated pins.
terminal through POE (Power Over Ethernet - IEEE802.3af or IEEE802.3at type 1
mode). According to the POE standard two modes are available: power on data pins
and power on dedicated pins.
Use either one of these modes depending on POE implementation on your local
Ethernet network.
Ethernet network.
Wi-Fi™ dongle must not be used with POE power supply. The POE doesn’t
provide enough power for both the terminal and the Wi-Fi USB dongle.
provide enough power for both the terminal and the Wi-Fi USB dongle.
Ethernet cable shall be shielded
Default Ethernet configuration
By default, MorphoAccess® SIGMA Lite Series terminal is configured in DHCP mode
Recommendations for RJ45 wiring
Pin
1
2
3
4
5
6
7
8
Signals
Data pair
1
Data pair
1
Data pair
2
NC/POE pin
dedicated (+)
NC/POE pin
dedicated (+)
Data
pair 2
Ground/ pin
dedicated (-)
NC/POE pin
dedicated (-)
EIA / TIA
T568B Colors
White
orange
Orange
White
green
Blue
White blue
Green White brown
Brown
EIA / TIA
T568A Colors
White
green
White
green
White
green
White green
White green
White
green
White green
White green
Corel L120
Colors
Grey
White
Pink
Orange
Yellow
Blue
Purple
Brown
Figure 21: RJ45 wiring
RJ45 plug pinout is compliant with 10/100 base T, IEEE802.3 Specification. Product is
compliant also with MDI or MDI-X.
compliant also with MDI or MDI-X.